Firmware Updates

* Check your current firmware version in ‘SETUP – INFORMATION’ – See Instruction manual. Upgrade to Firmware version 3.0.3 for enhanced camera options and remote control operation.

SOFTWARE UPGRADE METHOD BY COMPUTER

1. Download ISAW Extreme_FW.V.3.0.3
2. Unzip the file and extract A3_Firmware.UGF
3. Firmware Name: A3_Firmware.UGF
4. Connect USB to the computer while memory card is inside of camera
5. Camera POWER ON, then it will be automatically detected as “Removable Disk”
6. ** Battery must have at least 50% charge. **
7. Save Firmware file in “Removable Disk – ROOT FOLDER”
8. Take out USB Plug, automatic upgrade will be started.
9. ** Do not turn camera off during Upgrade**
10. Power will be off automatically when Upgrade is done.
11. Turn on Camera, and start to use.

SOFTWARE UPGRADE METHOD WITHIN CAMERA

1. Download ISAW Extreme_FW.V.3.0.3
2. Unzip the file and extract A3_Firmware.UGF
3. Firmware Name: A3_Firmware.UGF
4. Prepare the camera and format the memory card (**Back up all data before memory card format)
5. Save firmware file into empty memory card
6. Insert the memory card to the camera
7. Turn on the camera and automatic upgrade will be started.
8. Power will be off automatically when Upgrade is done.
9. Turn on Camera, and start to use.

* Do not power off, or take out battery during update.

* It need more than 50% power in order to upgrade camera. Please re-charge before start upgrade.

* Check your current firmware version in ‘SETUP – INFORMATION’

DOWNLOADS

Isaw Extreme Firmware V 3.0.3 (Requires remote update)

UPDATING THE REMOTE

Remote Driver V.2.0

Remote Software V 1.6.5

You need to install a driver before you upgrade the remote controller.

1. Upgrade Tool

• Unzip the Remote Driver V.2.0
• This is the remote controller upgrade tool for Window OS (Window XP ~ Window 7)

2. Upgrade Tool Installation

• In order to upgrade, you have to install 3 drivers.
• If you unzip the file, there is installation file. With this, it will automatically install all 3 drivers.

1. Click install32.bat or install64.bat(Depends of your computer OS 32bit or 64bit)
2. If your computer is 32bit system (Window XP) or 64bit system (Window7), you have to run appropriate file.
3. There will be some messages during installation. YES to all.
4. You will see the message all 3 drivers are installed.

* Now you’re ready to upgrade remote controller.

3. Upgrade Remote

• Plug in remote to computer with USB
• Remote power on.
• Click download.bat to input S/W into remote
• Wait 30 seconds to update.
• When update is done, remote power will automatically off.